Maintaining the Projector 177
9. Slide out the air filter on the bottom of the projector and
remove it.
10. Slide in the new air filter until it clicks in place.
11. Reset the lamp timer as described in the next section.
Resetting the Lamp Timer
After you replace the lamp, you need to reset the lamp timer using the
projector’s menu.
1. Press the
Menu button on the remote control or on the
projector’s control panel. You see the main menu.
2. Use the pointer button on the remote control (or the arrow
buttons on the projector) to highlight
Reset, then press Enter.
You see this screen:
To Next Page
Loading...
Need help?
General