200 Software Installation
Limitations in Windows Vista
If you install the Epson projector software in a previous version of
Windows and later upgrade to Windows Vista, you must uninstall the
software before you upgrade. Then reinstall it after you are running
Windows Vista.
EMP NS Connection V2.30 is compatible with Windows Vista, but
note the following:
■ If you are upgrading to Windows Vista and a USB display driver
is installed on your computer, uninstall it before upgrading to
Windows Vista.
■ The Multi-screen projection feature is not available.
■ When you project content from Windows Photo Gallery or
Windows Media Center, you cannot use the full-screen mode
options in those programs.
■ On the EMP NS Connection General settings tab, you cannot
select
Use full-screen video transfer.
■ You may find that you have to input your user account name into
the User Account Control screen each time you start EMP NS
Connection. To disable this, set the Windows Firewall setting to
On (recommended), click the Exceptions tab (in the Windows
Firewall Settings window), and register EMP NS Connection.
Mac System Requirements
Before you install the software, make sure your Mac meets the
following requirements:
■ Mac OS X 10.3 or later (OS X 10.3.9 to 10.4.5 recommended)
■ AirPort (802.11b) or AirPort Extreme (802.11g) wireless network
interface to use EMP NS Connection wirelessly
■ Power Macintosh series G3 900 MHz or more, iMac,
®
PowerBook, or iBook
■ At least 256MB of RAM
note
You can present over a
wireless network from
Mac OS X using EMP NS
Connection. However,
EMP SlideMaker and
EMP Monitor are available
only for Windows.
To Next Page
Loading...
Need help?
General