57
4l
Presenting Through a
Wireless Network
This chapter tells you how to send pictures to the projector through
a wireless network. Using EMP NS Connection, you can project
images shown on your computer screen—including text, graphics,
and video—directly to your audience. If you have Windows Vista,
you can also use the Network Projector feature to communicate with
your network-connected projector without installing any software.
You’ll find instructions in this chapter on:
■ Starting EasyMP
■ Configuring basic settings
■ Connecting to the projector in Ad Hoc (computer-to-computer)
mode or Access Point (infrastructure) mode
■ Using wireless security options
■ Projecting wirelessly
■ Multi-screen projection
■ Projecting video clips
■ Using special presentation modes
■ Using Windows Vista to connect to the projector
Before starting, make sure you’ve installed the wireless network
module as described on page 54. You must also install the EMP
NS Connection software as described on page 199 for each computer
you connect to the projector. Then follow the steps in this chapter to
start EasyMP, configure your projector and computer, and run EMP
NS Connection.
To Next Page
Loading...
Need help?
General