72 Presenting Through a Wireless Network
5. Check your wireless card’s or adapter’s device settings.
(Depending on the type of card or adapter you’re using, some of
the settings may be different than those listed here.)
■ Set the Network Type to Infrastructure.
■ Set the SSID to match the name assigned to the access point
(which should also match the projector’s SSID).
■ Make sure Encryption is Disabled if you have not set up
encryption on the projector.
6. Click the
General tab and make sure that your wireless card or
adapter is enabled.
7. When you’re done, click
OK to close the wireless properties dialog
box.
8. Right-click the
Wireless Network Connection icon again and
select
Properties. You see this screen:
To Next Page
Loading...
Need help?
General