Epson 2200 - Stylus Photo Color Inkjet Printer - Page 134

EPSON Stylus PHOTO 2100/2200 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly 134
4.2.4.1 Disassembling the ASF Unit
1. Remove the ASF Unit. (Refer to 4.2.4.)
2. Remove the one screw 8) C.B.P 3
×6 (6±1kgf.cm) that secures the Paper Guide
Support.
3. Release the two joggles of the Paper Guide Support with tweezers or like, and
while pulling the Paper Guide Support slightly to the front as viewed from the
ASF Unit rear, lift it up to release the three hooks, and remove the Paper Guide
Support.
Figure 4-28. Removing the Paper Guide Support
4. Remove the Extension Spring 0.088 hitched on the Right Lever Hopper Cam as
viewed from the ASF Unit front, and remove the Right Lever Hopper Cam from
the ASF Unit.
5. Release the one hook that secures the Spur Gear 32, and remove the Spur Gear 32
from the LD Roller Shaft.
Figure 4-29. Removing the Lever Hopper Cam/Spur Gear 32
Joggle
Paper Guide Support
Hooks
C.B.P 3×6
Joggle
C A U T I O N
When removing the Extension Spring 0.088, fully use care not to
lose it.
Refer to Figure 4-29, "Removing the Lever Hopper Cam/Spur
Gear 32".
Hook
Right Lever
Hopper Cam
Extension
Spring 0.088
Spur Gear 32