EPSON Stylus PHOTO 2100/2200 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly 155
14. Remove the one screw 9) C.B.S (P4) 3×6 (6±1kgf.cm) that secures the Right
Adjust Parallelism Bush, and while pulling the upper side (tooth surface) of the
Right Adjust Parallelism Bush to the front slightly as viewed from the printer right
side, turn it counterclockwise to release the two hooks, and then remove the Right
Adjust Parallelism Bush.
Figure 4-77. Removing the Right Adjust Parallelism Bush
15. Release the Shaft Fixing Plate (Right) from the joggle on the right of the Frame,
and turn it to remove from the Carriage Guide Shaft A.
Figure 4-78. Removing the Shaft Fixing Plate (Right)
16. Slide the Carriage Guide Shaft A to the right as seen from the printer front to
remove its left end from the Frame.
Printer right side
Hooks
C.B.S(P4) 3×6
Shaft Fixing Plate
(Right)
Carriage Guide
Shaft A
Joggle
To Next Page
Loading...
