EPSON Stylus PHOTO 2100/2200 Revision B
TROUBLESHOOTING Troubleshooting 87
Table 3-6. Phenomenon-Based Paper Jam Error Check Points
Occurrence Timing Phenomenon Detail
Faulty Part/
Part Name
Check Point Remedy
At power-on
(ASF, board paper
feed mode only)
At power-on, the PF roller turns
continuously for several seconds.
PE sensor 1. Check the paper detection area of the PE sensor for paper dust or
foreign matter.
2. Check that the PE sensor detection lever is in the proper position.
3. Check that the Sensor base is mounted to the Mechanical frame
correctly.
4. Move the Detection lever actively by hand in the same state as
when the paper passes, and check that the Detection lever is
returned to the original position automatically by the Torsion
spring when released.
1. Remove the paper dust and/or foreign matter
from the detection area.
2. Install the PE sensor detection lever in the
correct position.
3. Install the Sensor base correctly.
4. Change the PE sensor for a new one.
At operation At the time of paper ejection, the
PF roller advances the paper but
cannot eject it completely.
- 1. Check that the paper size used in the printer is not larger than the
paper size set on the driver side.
1. Since the paper length is larger than the
specifications, notify the user.
Detection lever
Torsion spring
Sensor base
To Next Page
Loading...
