Epson EB-PU2010B - Page 151

Projector Indicator Status
151
Indicator and status Problem and solutions
Power: Flashing blue
Status: Off
Laser: Off
Temp: Off
Filter: Off
Preparing to enter USB Power in Standby mode.
Power: Lit blue
Status: Lit blue
Laser: Flashing blue
Temp: Off
Filter: Off
A/V Mute is in progress.
Power: Indicator status
varies
Status: Flashing blue
Laser: Flashing orange
Temp: Indicator status
varies
Filter: Indicator status
varies
Refresh Mode is in progress.
s Reset > Refresh Mode
Power: Flashing blue
Status: Indicator status
varies
Laser: Indicator status
varies
Temp: Flashing orange
Filter: Indicator status
varies
Projector is too hot.
• Make sure that the vents and air filter are not clogged
with dust or obstructed by nearby objects.
• Clean or replace the air filter.
• Make sure the environmental temperature is not too
hot.
Indicator and status Problem and solutions
Power: Off
Status: Flashing blue
Laser: Off
Temp: Lit orange
Filter: Off
Projector has overheated and turned off. Leave it turned
off to cool down for 5 minutes.
• Make sure that the vents and air filter are not clogged
with dust or obstructed by nearby objects.
• Make sure the environmental temperature is not too
hot.
• Clean or replace the air filter.
• If operating the projector at high altitude, set the High
Altitude Mode setting to On in the projector's menu.
s Extended > Operation > High Altitude Mode
• If the problem persists, unplug the projector and
contact Epson for help.
Power: Flashing blue
Status: Indicator status
varies
Laser: Flashing orange
Temp: Indicator status
varies
Filter: Indicator status
varies
Laser warning.
Turn the projector off, unplug it, and contact Epson for
help.
Power: Flashing blue
Status: Indicator status
varies
Laser: Flashing orange
Temp: Indicator status
varies
Filter: Indicator status
varies
Lens warning.
An unsupported lens is attached; remove the
unsupported lens and attach a lens that is supported.
Power: Off
Status: Flashing blue
Laser: Lit orange
Temp: Off
Filter: Off
Laser or retardation plate has a problem.
Turn the projector off, unplug it, and contact Epson for
help.