Operating the Projector Power
36
a
• When the Direct Power On setting is set to On in the projector's
Extended menu, the projector turns on as soon as you plug it in.
Note that the projector also turns on automatically in cases such as
recovery from a power outage.
s Extended > Operation > Direct Power On
• If you select a specific port as the Auto Power On setting in the
projector's Extended menu, the projector turns on as soon as it
detects a signal or cable connection from that port.
s Extended > Operation > Auto Power On
gg Related Links
• "Home Screen" p.49
Turning Off the Projector
Turn off the projector after use.
a
• Turn off this product when it is not in use to prolong the life of the
projector. Light source life varies depending on the mode selected,
environmental conditions, and usage. Brightness decreases over time.
• Light source calibration starts automatically if you turn off the
projector and the following conditions are present:
• The Light Source Calibration setting is set to Run Periodically in
the projector's Reset menu
• 100 hours have passed since the last light source calibration
• You have used the projector continuously for more than 20
minutes
• Since the projector supports the direct shutdown feature, it can be
turned off directly using the breaker.
a
Press the [Standby] button on the control panel or remote control.
The projector displays a shutdown confirmation screen.
b
Press the [Standby] button again. (To leave it on, press any other
button.)
The projector beeps twice, the light source turns off, and the status
indicator turns off.
c
To transport or store the projector, make sure the status indicator on
the projector is off, and then unplug the power cord.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
