Solving Image or Sound Problems
158
Displaying From a Windows Laptop
If the message "No Signal" is displayed when projecting from a laptop, you
need to set up the Windows laptop to display on an external monitor.
a
Hold down the Windows key and press P on your keyboard at the same
time, then click Duplicate.
b
If the same image is not displayed by the laptop and projector, check
the Windows Display utility to make sure the external monitor port is
enabled and extended desktop mode is disabled.
c
If necessary, check your video card settings and set the multiple display
option to Mirror or Duplicate.
Displaying From a Mac Laptop
If the message "No Signal" is displayed when projecting from a Mac laptop,
you need to set up the laptop for mirrored display. (See your laptop manual
for details.)
a
Open the System Preferences utility and select Displays.
b
Select the Display or Color LCD option, if necessary.
c
Click the Arrange or Arrangement tab.
d
Select Mirror Displays.
Solutions When "Not Supported" Message Appears
If the message "Not supported" is displayed, try the following solutions:
• Make sure the computer's display resolution does not exceed the projector's
resolution and frequency limits. If necessary, select a different display
resolution for your computer.
Solutions When Only a Partial Image Appears
If only a partial computer image appears, try the following solutions:
• If you are projecting from a computer using a VGA computer cable, press
the [Auto] button on the remote control to optimize the image signal.
• Make sure you selected the correct Screen Type setting for the screen you
are using.
s Extended > Display > Screen > Screen Type
If there are margins between the edge of the image and the projected screen
frame, adjust the position of the image.
s Extended > Display > Screen > Screen Position
• Make sure the Scale setting is turned off in the projector's Signal menu.
• Try adjusting the image position using the Position setting in the
projector's Signal menu.
• Press the [Aspect] button on the remote control to select a different image
aspect ratio.
• Change the Resolution setting in the projector's Signal menu according to
the signal for the connected equipment.
• Change the Blanking setting in the projector's Signal menu so that the
image appears as you expect.
• If you zoomed into or out of the image using the [E-Zoom] buttons, press
the [Esc] button until the projector returns to a full display.
• Check your computer display settings to disable dual display and set the
resolution within the projector's limits.
• Check the resolution assigned to your presentation files to see if they are
created for a different resolution.
• When projecting in Content Playback mode, make sure you are using the
appropriate Overlay Effect settings.
s Settings > Content Playback > Overlay Effect
• Make sure you selected the correct Projection setting in the projector's
Extended menu.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
