Projector Parts and Functions
21
• "Geometry Correction" p.79
• "Memory" p.85
• "Split Screen" p.80
Installing Batteries in the Remote Control
The remote control uses the two AA batteries that came with the projector.
Attention
Make sure you read the Safety Instructions before handling the batteries.
a
Replace the batteries as soon as they run out. The remote control uses
two AA manganese or alkaline batteries.
a
Remove the battery cover as shown.
b
Remove the old batteries, if necessary.
a
Dispose of used batteries according to local regulations.
c
Insert the batteries.
Warning
Check the positions of the (+) and (–) marks inside the battery holder to
ensure the batteries are inserted the correct way. If the batteries are not used
correctly, they could explode or leak causing a fire, injury, or damage to the
product.
d
Replace the battery cover and press it down until it clicks into place.
Remote Control Operation
The remote control lets you control the projector from almost anywhere in
the room.
Make sure that you aim the remote control at the projector's receivers within
the distance and angles listed here.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
