Operating the Projector Power
35
Follow the instructions in these sections to operate the projector power.
gg Related Links
• "Turning On the Projector" p.35
• "Turning Off the Projector" p.36
Turning On the Projector
Turn on the computer or video equipment you want to use after you turn on
the projector.
a
Connect the power cord to the projector's power inlet and plug it into
an electrical outlet.
The projector's power indicator turns blue. This indicates that the
projector is receiving power, but is not yet turned on (it is in standby
mode).
b
Press the [On] button on the control panel or remote control to turn on
the projector.
The projector beeps and the status indicator flashes blue as the
projector warms up. Once the projector is warmed up, the status
indicator stops flashing and turns blue.
a
• When Quick Startup is enabled in the projector's Extended
menu, the projector becomes ready for use in several seconds
the next time you press the power button.
s Extended > Operation > Quick Startup
Try the following if you do not see a projected image.
• Turn on the connected computer or video device.
• Change the screen output from the computer when using a laptop
computer.
• Insert a DVD or other video media, and press play (if necessary).
• Press the [Search] button on the control panel or remote control to detect
the source.
• Press the button for the desired video source on the remote control.
• If the Home screen is displayed, select the source you want to project.
Warning
• Never look into the projector lens when the light source is on. This can damage
your eyes and is especially dangerous for children.
• When turning on the projector at a distance using the remote control, make sure
there is no one looking into the lens.
• During projection, do not block the light from the projector with a book or other
objects. If the light from the projector is blocked, the area on which the light
shines becomes hot which could cause it to melt, burn, or start a fire. Also, the
lens may get hot due to the reflected light which could cause the projector to
malfunction. To stop projection, use the A/V Mute function, or turn off the
projector.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
