111
The projector displays a shutdown confirmation screen.
Note: If Standby Confirmation is disabled and you press the power button on the remote control,
the confirmation screen is not shown and the projector shuts off.
2. Press the Standby button on the projector or remote control again. (To leave it on, press any other
button.)
The projector beeps twice, the laser turns off, and the Status light turns off.
Note: With Epson's Instant Off technology, there is no cool-down period so you can pack up the
projector for transport right away (if necessary).
Note: If the Light Source Calibration setting is set to Run Periodically in the projector's
Management menu, light source calibration starts automatically if you turn off the projector and the
following conditions are present:
• 100 hours have passed since the last light source calibration.
• You have used the projector continuously for at least 20 minutes.
3. To transport or store the projector, make sure the Status light is off, then unplug the power cord.
Note: If you use the projector continuously for more than 24 hours, or regularly turn it off by shutting off
the power outlet, schedule periodic Light Source Calibration events in the Extended menu schedule
settings.
Parent topic: Using Basic Projector Features
Related tasks
Turning On the Projector
To Next Page
Loading...
Need help?
General