209
You can only undo or redo the screen matching procedure if the Light Source Mode setting is set to
Custom.
Note: Wait 20 minutes after turning on the projector before using the Screen Matching feature and
darken the room for maximum accuracy. Brightness decreases over time, so you may need to perform
Screen Matching again to correct large differences in brightness.
Screen Matching Conditions
Matching the Screens Manually
Parent topic: Using Multiple Projectors
Related tasks
Saving a Scheduled Event
Screen Matching Conditions
You can use the screen matching feature under the following conditions:
• All of the projectors are the same model and the optional external camera is installed on each
projector.
• You are projecting on a matte white diffusion screen that is flat and even.
• The projectors are installed parallel to the screen.
• Nothing is blocking the optional external camera and the projected image.
• More than 20 minutes have passed after turning on the projectors.
• The projectors to be adjusted are grouped.
• The projected images do not overlap or have gaps between them, and they create a rectangular
image after tiling.
• The projection size for each projector is between 80 to 200 inches (203 to 508 cm).
• All of the projectors are connected to the same network and project images with the same resolution.
• The Blend Range setting for edge blending is set between 15 to 45%.
• The Projection setting for all projectors is set to Front or Front/Ceiling.
Parent topic: Matching Tint and Brightness (Screen Matching)
Related references
Projector Setup Settings - Extended Menu
To Next Page
Loading...
Need help?
General