47
Related tasks
Setting the Lens Type
Removing a Lens
You can remove a lens to replace it with a different lens. The projector uses a laser as the light source.
As a safety measure, the light source turns off when the lens is removed. Attach the lens, and then press
the On button to turn it back on.
Warning: Wait at least 30 minutes to remove or replace the lens after turning off the projector. Touching
the lens unit before it cools down may cause burns.
1. Press and hold the Lens Shift (remote control) or Lens (control panel) button for approximately 3
seconds to move the lens to the center position.
2. Turn off the projector and unplug the power cord.
3. Pull the lens replacement cover off of the projector.
To Next Page
Loading...
