284
Solutions When the Image is Fuzzy or Blurry
If the projected image is fuzzy or blurry, try the following solutions:
• Adjust the image focus. Make sure the projector has been on for at least 20 minutes before adjusting
the focus.
• Clean the projector lens.
Note: To avoid condensation on the lens after bringing the projector in from a cold environment, let the
projector warm up to room temperature before using it.
• Position the projector close enough to the screen.
• Position the projector so the keystone adjustment angle is not so wide that it distorts the image.
• Adjust the Sharpness setting in the Image menu to improve image quality.
• If you are projecting from a computer, press the Auto button on the remote control to automatically
adjust the tracking and sync. If any bands or overall blurriness remain, display a uniformly patterned
image on the screen and manually adjust the Tracking and Sync settings in the Signal menu.
• If you are projecting from a computer, try using a lower resolution or try to match the projector's native
resolution.
Parent topic: Solving Image or Sound Problems
Related concepts
Projector Connections
Related references
Projector Setup and Installation Options
General Projector Specifications
Image Quality Settings - Image Menu
Supported Monitor Display Resolutions
Related tasks
Focusing the Image Using the Focus Buttons
Cleaning the Lens
To Next Page
Loading...
