216
Setting Options Description
Source Signal Format
Overscan
Reset to Defaults
Displays settings selected for the current
input source
Signal Format: sets the signal type and
video range for certain input sources
• Video Signal: specifies the signal type
from input sources connected to video
ports; if interference appears or no image
appears when set to Auto, select the
appropriate signal type
• Video Range: sets the video range to
match the setting of an input source
connected to the HDMI ports
Overscan: changes the projected image
ratio to make the edges visible by a
selectable percentage or automatically
when projecting a component signal
Reset to Defaults: resets all settings for
the current input source
EDID HDMI1
HDMI2
Describes the display capabilities of your
projector when the selected input source is
HDMI; change this setting as necessary
according to the resolution of the current
input source
HDMI IN EQ Level HDMI1
HDMI2
Adjusts the HDMI input signal level
depending on the devices connected to the
HDMI port. Change the setting if there is a
lot of interference in the image or if no
image is projected.
To Next Page
Loading...
Need help?
General
