278
Related tasks
Setting the Date and Time
Solutions When You Cannot Access the Projector Through the Web
If you are unable to access the projector through a web browser, make sure you are using the correct ID
and password, which are case sensitive.
Note: You cannot change the user ID.
• For the user ID, enter EPSONWEB. (You cannot change the user ID.) For the password, enter the
password set in the projector's Network menu. No password is set by default.
• Avoid connecting via a proxy server.
• Make sure you have access to the network the projector is on.
• Check the IP address on the projector, then reenter the IP address in the browser search bar.
• If you set the Standby Mode setting to Communication On in the projector's Operation menu, make
sure the network device is turned on. After turning on the network device, turn on the projector.
Note: The user ID and password are case sensitive.
Parent topic: Solving Network Problems
Solutions When Network Alert E-Mails are Not Received
If you do not receive an e-mail alerting you to problems with a projector over the network, try the
following solutions:
• Make sure the projector is turned on and connected to the network correctly. (If an error shut down the
projector, it cannot send an e-mail.)
• Make sure you set up the projector e-mail alert settings correctly on the projector's Network Mail
Notification menu or in the network software.
• Set the Standby Mode setting to Communication On so the network software can monitor the
projector in standby mode. Change the Port setting according to your network environment.
Parent topic: Solving Network Problems
To Next Page
Loading...
Need help?
General
