269
• Make sure you selected the correct Projection setting in the Installation menu.
• If you are projecting in Content Playback mode, make sure you are using the correct Overlay Effect
setting in the Operation > Content Playback menu.
Parent topic: Solving Image or Sound Problems
Related references
Input Signal Settings - Signal I/O Menu
Installation Settings - Installation Menu
Image Quality Settings - Image Menu
Related tasks
Changing the Image Aspect Ratio
Zooming Into and Out of Images
Solutions When the Image is Not Rectangular
If the projected image is not evenly rectangular, try the following solutions:
• Place the projector directly in front of the center of the screen, facing it squarely, if possible.
• Turn on automatic keystone adjustments using the projector's menus.
• If you adjusted the projector height using the projector feet, press the keystone buttons on the
projector to adjust the image shape.
• Adjust the position of the projector's horizontal keystone slider.
• Adjust the Quick Corner setting to correct the image shape.
• Adjust the Arc Correction setting to correct the image shape when projecting onto a curved surface.
• Adjust the Point Correction setting to correct any slight distortion.
Parent topic: Solving Image or Sound Problems
Related references
Image Quality Settings - Image Menu
Installation Settings - Installation Menu
Related tasks
Correcting Image Shape with the Keystone Buttons
Correcting Image Shape with Arc Correction
Correcting Image Shape with Quick Corner
Correcting Image Shape with Point Correction
To Next Page
Loading...
Need help?
General
