To Next Page

To Previous Page

off). The Standby Mode setting is displayed only if the A/V Output setting in the Signal I/O menu is set

to While Projecting.

1. Make sure the projector is turned on.

2. Start your web browser on a computer or device connected to the network.

3. Type the projector's IP address into the browser's address box and press the computer's Enter key

(if you are entering an IPv6 address, wrap the address with [ and ]).

Note: You can find the projector's IP address in the projector's Network menu or on the LAN input

screen.

Note: If you attempt to connect to the Web Control screen via a proxy server, the screen will not be

displayed. Make a direct connection to the Web Control screen.

Caution: Do not remove the USB flash drive from the projector or disconnect the projector's power

cord when the Playlists or USB Memory Device screens are displayed in Content Playback mode.

Data saved on the flash drive may be damaged.

You see a Web Control screen like this.

In normal mode:

Epson EX11000 User Manual

Questions and Answers: