Epson FX-2190

Paper Handling 45
R4CC530
long.bk Rev. E
A5 size PAPER.fm
6/23/03
R
Proof Sign-off:
ABE J. Hashimoto, S. Yamamoto
H. Kimura
S. Halvorson
2
2
2
2
2
2
2
2
2
2
2
2
6. Fit the holes of the paper over the pins on both sprockets of
the pull tractor.
c
Caution:
Do not pull up the paper by hand to fit it on the pull tractor;
this may damage the printer. Press the LF/FF button to move
the paper.
7. Set the paper release lever to the pull tractor position. Then
use the Micro Adjust function (described in “Using the Micro
Adjust Function” on page 62) to remove any slack in the paper
between the push and pull tractors.
8. Move the paper release lever back to the position you set in
step 3.
9. When the printer receives data, it will start printing at the
current position without advancing the paper. If necessary,
follow the steps in “Adjusting the top-of-form position” on
page 64 to adjust the current position of the paper.
10. Attach the printer cover. Make sure the paper guide is
installed and lying flat on the printer.
Note:
For your safety, EPSON recommends operating the printer with the
printer cover closed. The printer will function with the printer cover
open or removed, but maximum safety and print speed are achieved
when the cover is closed.
11. Send a print job to the printer. The printer starts printing from
the current position without advancing the paper. After you
finish printing, tear off the printed document at the
perforation nearest the paper exit slot.