EasyManuals Logo

Epson FX-870 Service Manual

Epson FX-870
181 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
FCC Compliance Statement
For American Users
This equipment has been tested and found to comply with limits for a Class B digital device pursuant to Part
15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio or television
reception. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause interference to radio or television reception, which can be determined by turning the
equipment on and off, the user is encouraged to try to correct the interference by one or more of the following
measures:
l
Reorient or relocate the receiving antenna.
l
Increase the separation between the equipment and the receiver.
l
Connect the equipment into an outlet on a circuit different from the one connected to the receiver.
For Canadian Users
This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus as
set out in the radio interference regulations of the Canadian Department of Communications.
Le present appareil numcrique n’cmet pas de bruits radkklectrique d&passant lea limites applicables aux
appareils numcriques de Classe B prescrites dans le rkglement sur le brouillage radioGctriques tdictk par le
Minis&e des Communications du Canada.
The connection of a non-shielded equipment interface cable to this equipment will invalidate the FCC
Certification of this device and may cause interference levels which exceed the limits established by the FCC
for this equipment. It is the responsibility of the user to obtain and use a shielded equipment interface cable
with this device. If this equipment has more than one interface connector, do not leave the cables connected
to unused interfaces.
Changes or modifications not expressly approved by the manufacturer could void the user’s authority to
operate the equipment.
ii
Epson
f%87W1170

Table of Contents

Other manuals for Epson FX-870

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson FX-870 and is the answer not in the manual?

Epson FX-870 Specifications

General IconGeneral
BrandEpson
ModelFX-870
CategoryPrinter
LanguageEnglish

Related product manuals