Epson FX-870 Service Manual

Printer Features
-.
Buzzer
The buzzer beeps for 0.1 second at a time. These beep sounds are combined in various
ways, as shown below, to indicate different meanings. In the following table, each ”
l ”
stands for one beep.
Table 1-21. Buzzer Functions
Status Sound
Description
3EL code
0
Sounds when a BEL code is received.
Zarriage trouble - -
A carriage error has occurred.
Joltage error No beeps.
(Indicators blink sequentially in the
clockwise direction.)
=atal error
No beeps.
(Indicators blink simultaneously.)
ncorrect memory m w a y
- RAM
0.ae.0ao.0
- E*PROM
‘aper error
- - - - - Continuous paper has run out.
Paper in the CSF has run out.
Paper was not present at the start of a
self-test.
A sheet could not be ejected from the
CSF.
no
Anotherpaperdetectionerroroccurred:
With single-sheet feed selected, no
paper is present.
Illegal paper
- . . .
release/unrelease
Recognition of l
operation
Continuous paper can’t be loaded.
Paper runs out after the PAPER FEED
button is pressed.
(continuously till corrected)
The release lever was changed while
there was paper in the paper path.
Change the lever again or remove the
paper in the path to stop the sound.
Power-on operation (self test, hex
dump, default setting, or power-on)
CSF bin -1 selected.
Micro feed
”
.
- . . .
CSF bin -2 selected.
The adjusted value set with micro feed
is the same as the factory setting value
(loading position or tear-off position).
(continuously until button is released)
The micro feed value has reached its
upper or lower limit.
Epson FX-870/1170
1-27

Epson FX-870 Specifications

General

Brand	Epson
Model	FX-870
Category	Printer
Language	English