128 Control Panel
Note:
❏ Before entering the lock-out setting mode, you need to load A4 or
letter size single-sheet paper or continuous paper that is at least 210
mm (8.3 inches) wide. See “Loading Continuous Paper” on page 14
and “Loading Single Sheets” on page 48 for instructions on loading
continuous paper and single sheets.
❏ The setting instructions are printed in the language that you set in
the default-setting mode. If you want to change the language of the
setting instructions, change the language setting by changing the
default setting. See “Changing default settings” on page 124 for
instructions on changing the default setting.
❏ For your safety, Epson recommends operating the printer with the
printer cover closed. The printer will function with the printer cover
open or removed, but for maximum safety keep the cover closed.
Follow these steps to change the lock-out mode setting:
1. Make sure paper is loaded and the printer is turned off.
c
Caution:
Whenever you turn off the printer, wait at least five seconds
before turning it back on; otherwise, you may damage the
printer.
2. Turn on the printer while holding down both the LF/FF and
Pause buttons.
The printer beeps and enters the lock-out setting mode and
prints a message asking if you wish to print all of the current
settings.
3. If you want to print the current settings, press the Set button.
If you want to bypass printing of the current settings, press
the ItemD button or the ItemU button.
The printer prints the first menu and the current value of the
menu.
To Next Page
Loading...
