140 Problem Solver
The printer does not fully eject a single sheet.
Cause What to do
Paper is too long. Press the Load/Eject button to eject the
sheet. Make sure the page length of your
paper is within the range specified for
single-sheet paper in “Paper” on page
218. Also check and adjust the paper size
setting in your application or printer
driver.
The paper does not feed properly with the optional cut-sheet
feeder.
Cause What to do
The cut-sheet feeder is not
installed properly.
Reinstall it as described in “Installing
the cut-sheet feeder” on page 176.
Too many sheets are loaded in
the cut-sheet feeder. You
cannot load more than 150
sheets of paper in the
high-capacity cut-sheet feeder.
Load less than 150 sheets of paper. See
“Cut-Sheet Feeder” on page 175 for
more information.
The edge guides of the
cut-sheet feeder are not
positioned correctly.
Align the left edge guide with the arrow
mark, then move the right edge guide to
match your paper’s width.
There is only one sheet left in
the bin.
Add more paper to the cut-sheet feeder.
To Next Page
Loading...
