14 Paper Handling
8. To separate the incoming paper from the printed paper,
attach the paper guide by holding it horizontally and fitting
its notches over the printer’s mounting posts as shown
below. Then slide the paper guide toward the front of the
printer until you feel it click.
9. Replace the printer cover and close it.
10. Turn on the printer.
11. When using the push tractor, it is a good idea to turn on the
Auto tear off feature in Default Setting mode. See page 67.
12. Press the LF/FF button to feed the paper to the loading
position. When the printer receives data, it begins printing
automatically.
13. After you finish printing, follow the steps in the next section
to tear off your printed document. If the first printed line on
your page appears too high or too low, you can change its
position using the Micro Adjust feature. See “Adjusting the
top-of-form position” on page 22.
c
Caution:
Never use the paper feed knob to adjust the top-of-form position;
this may damage the printer or cause it to lose the top-of-form
position.
The next time you print, the paper automatically feeds back to
the loading position.
To Next Page
Loading...
Need help?
Power
Performance
Weight and Dimensions
