You also may need to modify existing presentation files if you created
them for a different resolution. See your software manual for specific
information.
D
The message NO SIGNAL is displayed.
An image source not connected to the projector is selected, the signal is
not being output from the computer, or the signal is not reaching the
projector. Make sure the connectors are securely attached to both the
projector and the image source. Then check that the image source is
selected correctly. When NO SIGNAL is displayed, you cannot access
the source (computer/video) menu.
D
A
blank screen is displayed.
The computer signal cannot be interpreted by the projector. Verify the
display format (see page 95). When
y
ou see a blank screen, you cannot
access the projector menus.
D
The image or parts of the image are blurred or not in focus.
Adjust the Brightness and Contrast settings on the Video main menu.
If you’re viewing a computer image, also try adjusting the Comp
Tracking and Comp Sync buttons on the projector’s control panel.
There may be dirt or smears on the lens. Glean the lens as described in
Chapter 5, “Maintenance.”
Problems with the Image or Sound
To Next Page
Loading...
Need help?
General