Using the Remote Control
pointer button
multi-purpose
button
’
bottom
multi-purpose button
The remote control uses a line-of-sight infrared signal. To use the
remote control, point it towards one of the remote control receivers
located at the front and back of the projector.
You can use the remote control up to about 33 feet (10 meters) from
the projector. (This distance may be shorter if the remote control
batteries are low.)
Note: The projector may not respond to remote control commands in these
conditions.. ambient hgh t is too bright,’ a certain type of fluorescent light is
present; a strong light source (such as direct sunlight) shines into the
Using the Remote Control
To Next Page
Loading...
Need help?
General