When you want to stop projecting images, press the Power button
again. The fan remains on, the projection lamp indicator flashes
orange for about 60 seconds, and the power indicator changes to
orange as the projector cools off.
When the projector has cooled off, flashing stops and the power
indicator changes to orange.
Note: If you press the Power button to turn the projector back on while the
power indicator is orange, there may be a delay before a projected image
appears.
Sleep Mode
Sleep mode conserves electricity by automatically turning off the lamp
after the projector has not been used for 30 minutes. In sleep mode,
the projector’s power indicator is orange and only a minimum amount
of the projector’s circuitry remains on. This conserves electricity, cools
the projector, and extends the life of the lamp. When the projector is
in sleep mode, you can press the Power button to start projecting
images, or you can unplug the projector’s power cord.
2 l Using the Projector
To Next Page
Loading...
Need help?
General