Epson PowerLite 5000 - Turning the Equipment on and off; Turning the Projector on and off

Turning the Equipment On and Off
Always turn on the projector and its attached equipment in the
following order:
1.
Video source (such as a VCR), if your video source is not your
computer
2.
Audio source (if different from computer or video source)
3. Projector
4.
External amplified speaker or PA system (if necessary)
5. Computer
Turning the Projector On and Off
1.
Remove the projector lens cap.
2.
Press the Power button on the remote control or control panel.
The green power indicator comes on.
If computer or video equipment is attached, the computer or video
signal is projected.
Allow about 30 seconds for full illumination.
+
warning: Never look into the lens when the lamp is on. This can damage
your eyes. It is especially important that children not look into the lens.
Turning the Equipment On and Off