Installing the Software
ELP Link II software can be used with the following operating systems:
l Windows 3.x
l Windows 95
l Macintosh OS System 7.
Connecting Needed Cables
Before installing the software, make sure the projector is properly
connected to your computer. See Chapter 1, “Installation,” for
instructions about how to install the serial and mouse cables needed to
use the Link II software.
Installing the Software from Windows 3.x
Perform the following steps to set up the software for Windows 3.x.
1.
Insert the Link II for Windows installation diskette into a diskette
drive (A: or B: as appropriate).
4 l Using the ELP Link II Software
To Next Page
Loading...
Need help?
General