To connect a video source to the projector:
1.
2.
3.
4.
Turn off the projector and video source if they are on.
If your video source uses a small, round, one-prong composite
(RCA) video connectors, you’ll need the audio/visual cable that
comes with the PowerLite 5000. If your video source uses a large,
round, four-prong S-video connector, you will need to purchase
an S-video cable.
For composite video, connect the yellow RCA plug on one end of
the audio/visual cable to the projector’s Video In jack. Connect
the other yellow RCA plug to the video-out jack of your video
source.
Connect the other plugs on the audio/visual cable to the Audio In
jacks of the projector: insert the white plug into the L Audio In
jack and the red plug into the R Audio In jack. Connect the plug
at the other end of the audio/visual cable to the audio output jacks
of the video source.
Connecting to a Computer
To Next Page
Loading...
Need help?
General