Note: The computer must be connected and operating, and the image
source on the projector must be set to computer for you to access these menu
options.
Menu item Description
Brightness Lightens or darkens the overall image. Increase brightness to lighten
an image, or decrease it to darken the image.
Contrast Adjusts the difference between light and dark areas. Increase the
contrast to make light areas lighter and dark areas darker. Decrease it
to minimize the difference between light and dark areas.
Sync Synchronizes with the tracking signal sent from the computer. Adjust
this setting to correct fuzziness or to remove streaks from the image.
Tracking Matches the projector’s internal clock to various computer graphic
signals Adjust this setting to remove fuzzy lines from the image.
Color Adjusts the color balance of the input source.
Select this item and then press the Enter button (control panel) or
either multi-purpose button (remote) to enter the color adjustment
mode. Then use the pointer button or up and down buttons (control
panel) to select a color.
Next, use the pointer button or left and right buttons (control panel) to
adjust the selected color. Increase the color setting for more intense
color on the screen, and lower the setting for less intense color.
When you finish making adjustments, press the Enter button (control
panel) or a multi-purpose button (remote) to return to the Computer
menu.
3 l Using the Projector Menus
To Next Page
Loading...
Need help?
General