Epson RC700 Series Maintenance Manual

Maintenance 6. Alarm
30 RC700 Series Maintenance Rev.3
6.1.3 How to Edit the Alarm Information
The configured alarm information can be edited in the EPSON RC+ 7.0.
(1) Select EPSON RC+ 7.0 menu-[Tools]-[Maintenance] to display the [Controller
Tools] dialog box.
(2) Select the alarm to be changed and click the <Change> button.
(3) Display the [Change Alarm] dialog box and enter any of the followings.
Purchase or replacement date of the battery
Date of grease up
(4) Click the <OK> button and change the specified alarm information.
6.1.4 Alarm Notifying Method
The alarm notifying method needs to be configured by the output bit of the Remote I/O.
The Remote I/O can be configured in the EPSON RC+ 7.0- [Setup] - [System
Configuration] - [Controller] - [Remote Control].
For details, refer to the EPSON RC+ 7.0 User’s Guide 12.1 Remote I/O.
The Controller does not enter the error or warning state even if an alarm occurs.

NOTE

Epson RC700 Series Specifications

General

Model	RC700 series
Category	Controller
Programming Language	SPEL+
Safety Standard	ISO 10218-1
Type	Robot Controller
Communication Interface	Ethernet, RS-232, USB
Operating Temperature	0°C to 45°C (32°F to 113°F)
Humidity	20% to 80% (non-condensing)
Number of controllable robots	4