Epson RC700 Series Maintenance Manual

Maintenance 5. Firmware Update
RC700 Series Maintenance Rev.3 23
5.5 Adding Confirmation Steps by Strengthening Security of EtherNet
Connection
From the following firmware version password authentication is required when connecting
Controllers and PCs to a global accessible network.
F/W : Ver.7.4.8.x
In the following cases, connections of EtherNet (PC) connector and Remote Ethernet are
not available.
Controller IP address is set to global IP address
Firmware version is 7.4.8.x or later
EPSON RC+7.0 is Ver.7.4.7 or before
When the Controller firmware is updated under the following conditions, additional steps to
confirm whether to continue the firmware update may be execute depending on the
configuration settings of the Controller. (step 3 or later shown below)
Controller IP address is set to global IP address
Firmware version to be installed is 7.4.8.x or later
The following describes the steps to confirm whether to continue the firmware update.
(1) Insert “Firmware CD-ROM” to be installed into the CD-ROM driver of the
development PC.
(2) Execute “CtrlSetup70.exe”.
(3) Controller Setup window is displayed.
Select the <Upgrade> button and click the <Next> button.

Epson RC700 Series Specifications

General

Model	RC700 series
Category	Controller
Programming Language	SPEL+
Safety Standard	ISO 10218-1
Type	Robot Controller
Communication Interface	Ethernet, RS-232, USB
Operating Temperature	0°C to 45°C (32°F to 113°F)
Humidity	20% to 80% (non-condensing)
Number of controllable robots	4