Epson RC700 Series Maintenance Manual

Maintenance 5. Firmware Update
24 RC700 Series Maintenance Rev.3
(4) Step 2 window is displayed.
Click the <Next> button.
(5) Step 3 window is displayed.
(5)-1 When the steps to confirm whether to continue the firmware update is not executed:
Step 3 window is displayed.
Follow the instructions on the window and install the firmware.
(5)-2 When the steps to confirm whether to continue the firmware update is executed:
The following window is displayed.
When the <I understand the contents> button is selected, the <OK> button will be
enabled.
When the <OK> button is clicked, Step3 window is displayed. Go to the step (6).
When the <Cancel> button is clicked, Step3 window is displayed. The [Disable
connection password] checkbox and the <Install> button will be grayed out and
cannot be selected.

Epson RC700 Series Specifications

General

Model	RC700 series
Category	Controller
Programming Language	SPEL+
Safety Standard	ISO 10218-1
Type	Robot Controller
Communication Interface	Ethernet, RS-232, USB
Operating Temperature	0°C to 45°C (32°F to 113°F)
Humidity	20% to 80% (non-condensing)
Number of controllable robots	4