Epson RC700 Series Maintenance Manual

Maintenance 5. Firmware Update
RC700 Series Maintenance Rev.3 25
(6) Step 3 window is displayed.
(6)-1 If the [Disable connection password] checkbox is selected, connection
authentication after updating the firmware is disabled.
(6)-2 If the <Install> button is clicked, the confirmation window is displayed.
When the [Disable connection password] checkbox is selected:
When the [Disable connection password] checkbox is not selected:
When the <OK> button is clicked, Step 4 window is displayed. Go to the step (7).
When the <Cancel> button is clicked, the window is closed.
(7) Firmware installation starts.
When the firmware is installed, click the <Next> button. Reboot the Controller.

Epson RC700 Series Specifications

General

Model	RC700 series
Category	Controller
Programming Language	SPEL+
Safety Standard	ISO 10218-1
Type	Robot Controller
Communication Interface	Ethernet, RS-232, USB
Operating Temperature	0°C to 45°C (32°F to 113°F)
Humidity	20% to 80% (non-condensing)
Number of controllable robots	4