Messages What to do
3 layer printing is only available with 2
Head Mode.
SC-S80600 Series/SC-S60600 Series only
When one head mode is set, three layered printing cannot be performed. Set
two head mode, and then perform three layered printing.
Change head mode U “The Printer Setup Menu” on page 98
When a Maintenance Call/Service Call Occurs
Error messages What to do
Maintenance Request
Replace Part Now/Replace Part Soon
XXXXXXXX
A part used in the printer is nearing the end of its service life.
Contact your dealer or Epson Support and tell them the maintenance request
code.
You cannot clear the maintenance request until the part is replaced. A service
call occurs if you continue to use the printer.
Call For Service
XXXX Error XXXX
Power off and then on. If this doesn't
work, note the code and call for service.
A call for service occurs when:
❏ The power cable is not connected securely
❏ An error that cannot be cleared occurs
When a call for service has occurred, the printer automatically stops printing.
Turn off the printer, disconnect the power cable from the outlet and from the
AC inlet on the printer, and then reconnect. Turn on the printer again multiple
times.
If the same call for service is displayed on the LCD panel, contact your dealer or
EpsonSupport for assistance. Tell them the call for service code is "XXXX".
SC-S80600 Series/SC-S60600 Series/SC-S40600 Series User's Guide
Problem Solver
107
To Next Page
Loading...
Need help?
General