To Next Page

To Previous Page

Note:

You can confirm differences in tension by lightly

tapping both edges of the media as shown in the

illustration below.

Continue holding down the d button until

both edges of the media reach the paper core

and wrap around once or twice.

Settings for Loaded Media

When you have finished loading the media, follow the

instructions on the control panel to make settings for

the loaded media.

1. Select the media setting number

Select the media setting number to which the print

settings have been registered.

2. Select the roll winding specifications

Select the roll type for the loaded media roll.

3. Set the media length

Set the length of the loaded media.

Buttons that are used in the following settings

Use the d/u buttons to select the media setting

number to which the print settings have been

registered, and then press the Z button.

OK Done

Select Media

If media settings have not yet been made for

new media, select an unassigned number, finish

loading the media, and then perform Easy

Media Setup.

SC-S80600 Series/SC-S60600 Series/SC-S40600 Series User's Guide

Basic Operations

Epson SC-S60600 Series User Manual

Other manuals for Epson SC-S60600 Series