Details of the Menu
The Media Setup Menu
The Media Setup menu can be accessed directly by pressing the M button.
* indicates default settings.
Feed To Cut Position
Sends the end of the print to the cutting groove.
Easy Media Setup
You can quickly and easily register media settings using the Wizard to perform optimum printing according to the
size and type of the media being used.
U “Saving New Media Settings” on page 45
Media Remaining
Item Parameter Explanation
Print Remaining Length Print
Use Print Remaining Length to print the amount of media remaining
on the current roll before replacing it with another type of media. You
can then enter this number as the media the length the next time the
roll is used.
Length OFF, 1.0 to 100.0
m (30
*
)
Enter a value for overall roll length between 1.0 and 100.0 m. You can
set in 0.5m increments. When you select OFF, the following remaining
amount is not calculated.
❏ Display remaining amount of media on the control panel screen
❏ Display warning message for remaining amount of media
Remaining Alert
1 to 15 m (5
*
)
An alert will be displayed if the amount of media remaining reaches this
length. Choose from values between 1 and 15 m. You can set in 1 m
increments.
SC-S80600 Series/SC-S60600 Series/SC-S40600 Series User's Guide
Using the Control Panel Menu
93
To Next Page
Loading...
Need help?
General