Printing the Amount of Media
Remaining
By printing the remaining amount on the media being
removed, you can check this value the next time the
media is loaded and enter the media length. This is
useful for accurate management of the amount of
media remaining. The remaining amount cannot be
printed when Remaining Setup is set to OFF.
The following section describes how to print the
amount of media remaining.
Buttons that are used in the following settings
A
Confirm that the printer is ready to print.
B
Press the M button, select Media Remaining,
and then press the Z button.
C
Select Print Remaining Length and press the
Z button.
D
Press the Z button to print the amount of
media remaining.
Cutting Media
Caution:
❏ The heaters and media edge plate may be hot;
observe all necessary precautions. Failure to
observe the necessary precautions could result
in burns.
❏ When cutting media, be careful not to cut
your fingers or hands with the cutter or other
blades.
A
Press the M button, select Feed To Cut
Position, and then press the Z button.
The trailing edge of the print is fed to the cut
position (cutter groove).
If you have printed the amount of media
remaining, press the u button to rewind the
media until this information appears on the roll
side beyond the cutter groove so that it will
remain on the roll after the media is cut.
SC-S80600 Series/SC-S60600 Series/SC-S40600 Series User's Guide
Basic Operations
42
To Next Page
Loading...
Need help?
General