Epson Stylus C110 - Page 46

EPSON Stylus C110/C120/D120 Revision B
TROUBLESHOOTING Troubleshooting 46
Note : "–": No Change
"Brink 1": 1.25 sec. on + 1.25 sec. off
Printer Status Replace Ink Cartridge or No Ink Cartridge CSIC Error Incorrect I/C Paper Jam
Indications
Power — — — —
Ink On On On —
Paper — — — Brink 1
Status monitor 3
message
Fault
Occurrence
Cause
This error occurs when any one of the
followings is detected.
• 100 percent of ink has consumed.
• The ink cartridge is defective.
Note :
The ink cartridge still has a small amount of
ink even after the error. This is to prevent the
Printhead nozzles from being damaged by
printing without ink.
This error occurs when data from CSIC
cannot be read normally or when data
cannot be written to CSIC.
This error occurs when any one of the
followings is detected.
• An unsupported ink cartridge has been
installed.
• An ink cartridge with a different
destination has been installed.
This error occurs when the PE Sensor
failed to detect the paper bottom edge
during paper feeding sequence.
Reference Page
Table 3-7, “Check point for no ink
cartridge/CSIC error/incorrect ink
cartridge according to each
phenomenon,” on page 56
Table 3-7, “Check point for no ink
cartridge/CSIC error/incorrect ink
cartridge according to each
phenomenon,” on page 56
Table 3-7, “Check point for no ink
cartridge/CSIC error/incorrect ink
cartridge according to each
phenomenon,” on page 56
Table 3-6, “Check point for paper jam
error according to each phenomenon,” on
page 53