Epson Stylus C110 - Page 57

EPSON Stylus C110/C120/D120 Revision B
TROUBLESHOOTING Troubleshooting 57
Table 3-8. Check point for paper out error according to each phenomenon
Occurrence timing
CR position
Detailed phenomenon
Defective unit/
part name
Check point Remedy
• Operation
•–
The LD Roller cannot pick up paper
although the LD Roller attempt to rotate
correctly.
ASF Unit
1. Check if any paper dust is not adhered to the surface of
the LD Roller.
1. Set a cleaning sheet in the ASF Unit up side
down. Then holding the top edge, try to load the
paper from the Printer driver. The micro pearl
on the LD Roller surface is removed. To
remove severe smear, staple a cloth moistened
with alcohol to a post card and clean the roller
in the same manner.
*If the problem is not solved, replace the ASF
unit with new one.
The Hopper does not operate during the
paper loading sequence although the LD
Roller rotates to load paper from the ASF
Unit.
Hopper
1. Check if the Hopper operates correctly in the paper
loading sequence.
1. Reassemble the Compression Spring 1.94
between the Base Frame and the Hopper.
LD Roller
Non-adhesive Area
Staplers
Cloth moistened
with alcohol
CL Sheet
Adhesive Area
(Use a post card for
the base sheet)
This side down
Hopper
Compression Spring 1.94