Epson STYLUS PRO 9400 - Page 226

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Disassembly & Assembly Disassembly Procedure 226
3. Open the ROLL TOP COVER.
4. Remove the 14 screws that secure the COVER, REAR.
 Ten C.B.S. M4 x 6 screw
 One C.B.S. M3 x 6 screw
 One C.B. M3 x 6 screw
 Two hex socket screws
5. Close the ROLL TOP COVER.
6. Release the COVER, REAR from the two guide pins and remove the COVER,
REAR.
Figure 4-26. Removing the COVER, REAR
C H E C K
P O I N T
The Stylus Pro 7400/7800 use ten screws to secure the COVER,
REAR.
 Six C.B.S. M4 x 6 screws
 One C.B.S. M3 x 6 screw
 One C.B. M3 x 6 screw
 Two hex socket screws
C.B.S. 4x6
C.B.S. 3x6
C.B. 3x6
Hex socket screw
COVER, REAR
6
6
Guide
Pins
3
5