Epson STYLUS PRO 9400 - Page 225

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Disassembly & Assembly Disassembly Procedure 225
4.2.3.6 COVER, REAR
1. Remove the two screws that secure the COVER, CONNECTOR, UPPER; B and
remove it. See Figure 4-24.
 Two C.C.S. M3 x 12 screws
2. Remove the two screws that secure the COVER, I/F and remove it together with
the GROUND PLATE, IF. See Figure 4-25.
 Two C.B.S. M3 x 6 screws
Figure 4-24. Removing the COVER, CONNECTOR, UPPER; B
Figure 4-25. Removing the COVER, I/F and the GROUND PLATE, IF
C.C.S 3x12
COVER, CONNECTOR, UPPER; B
Right Rear of the Printer
C.B.S 3x6
GROUND PLATE, IF
COVER, I/F