Epson STYLUS PRO 9400 - Page 224

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Disassembly & Assembly Disassembly Procedure 224
4.2.3.5 L SIDE COVER ASSY.
1. Remove the Maintenance Tank. See Section 4.2.2.2 on page 217.
2. Remove the Spindle. See Section 4.2.2.4 on page 219.
3. Remove the H Top Cover Assy. See Section 4.2.3.2 on page 221.
4. Remove the I/H COVER L ASSY. See Section on page 222.
5. Remove the Side Cover Screw Cap.
6. Remove the eight screws that secure the L SIDE COVER ASSY. and remove it.
 Three C.B.P. M4 x 12 screws
 One C.F.P. M4 x 12 screw
 Four C.C.S. M4 x 8 screws
Figure 4-23. Removing the L SIDE COVER ASSY.
C A U T I O N
Ink may leak from the Cleaning Unit while or after removing the L
SIDE COVER ASSY. Have a waste cloth beforehand to wipe out
the leaked ink. When the L SIDE COVER ASSY. must be removed
for many hours, set the Maintenance Tank to collect ink leaked
from the Cleaning Unit.
C H E C K
P O I N T
The Stylus Pro 9400/9800 have two Maintenance Tanks, and the
7400/7800 have one tank on its right side.
C A U T I O N
Never forget to reattach the Side Cover Screw Cap, or the printer
may malfunction due to noise occurred in the internal electric
circuits. The caps are necessary to prevent the noise.
Make sure that there is no gap between the L SIDE COVER ASSY.
and the frame, then screw the L SIDE COVER ASSY.
C.F.P. 4x12
C.B.P. 4x12
C.B.P. 4x12
Side Cover
Screw Cap
C.C.S. 4x8
5
L SIDE COVER ASSY.
6