Epson STYLUS PRO 9400 - Page 275

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Disassembly & Assembly Disassembly Procedure 275
4.2.7.3 HOLDER ASSY., IC, RIGHT,
HOLDER ASSY., IC, LEFT
HOLDER ASSY., IC, RIGHT
1. Remove the R SIDE COVER ASSY. See Section 4.2.3.4 on page 223.
2. Release the four TUBE, SUPPLY, INK from the four retaining tabs and the
retaining clip.
3. Disconnect the four FFCs from the CSIC RELAY BOARD.
4. Lower the I/C, LOCK LEVER.
5. Remove the piece of the acetate tape that secures the harness of the I/C LEVER
SENSOR R.
6. Release the two tabs that secure the I/C LEVER SENSOR R and remove it.
7. Remove the connector from the I/C LEVER SENSOR R.
Figure 4-119. Releasing the TUBE, SUPPLY, INK and Removing the I/C LEVER
SENSOR R
Make sure that the four TUBE, SUPPLY, INK are routed behind
the screwed tab.
Figure 4-118. Routing the TUBE, SUPPLY, INK
Right Front of the Printer
Screwed tab
2: Retaining tabs
Retaining clip
I/C, LOCK
LEVER
Connector
FFC
4
Acetate tape
I/C LEVER
SENSOR R
Connector
6: Tabs
TUBE, SUPPLY, INK
HOLDER ASSY.,
IC, RIGHT