Epson STYLUS PRO 9400 - Page 276

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Disassembly & Assembly Disassembly Procedure 276
8. Release the harness of the I/C LEVER SENSOR R from the three hooked tabs of
the HARNESS/TUBE STOPPER and pull out the harness.
9. Pull out the TUBE, PRESSURIZING from the HOLDER ASSY., IC, RIGHT, and
release it from the three retaining clips of the HARNESS/TUBE STOPPER.
Figure 4-121. Releasing the I/C LEVER SENSOR R Harness and the TUBE,
PRESSURIZING
 Make sure that the joint of the TUBE, PRESSURIZING is
located at the retaining clip as shown in the figure below.
Figure 4-120. Routing the TUBE, PRESSURIZING
 Insert the TUBE, PRESSURIZING all the way.
Joint
Retaining clip
HARNESS/TUBE STOPPER
TUBE,
PRESSURIZING
8: Hooked tabs
8: Hooked tabs
I/C LEVER SENSOR
R Harness
9: Hooked tabs