Epson STYLUS PRO 9400 - Page 277

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Disassembly & Assembly Disassembly Procedure 277
10. Remove the four screws that secure the HOLDER ASSY., IC, RIGHT.
 Four C.C.S. M4 x 8 screws
11. Release the hooked tab that secures the HOLDER ASSY., IC, RIGHT, and
remove it.
Figure 4-123. Removing the HOLDER ASSY., IC, RIGHT (1)
C A U T I O N
When performing the next step, be careful not to pull the HOLDER
ASSY., IC, RIGHT too much as it is still connected to the printer
with the TUBE, SUPPLY INK.
Make sure to insert the two tabs of the HOLDER ASSY., IC,
RIGHT into the two slots.
Figure 4-122. Reinstalling the HOLDER ASSY., IC, RIGHT
Tabs
C.C.S. 4x8
C.C.S. 4x8
Hooked tab
11-1
11-2