EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Product Description Control Panel 38
Note "*1": In actual operation, two seconds are enough. (It does not mean that the printer works immediately after the two seconds.)
"*2": The printer is always turned OFF regardless of operation status.
"*3": The printer starts to function within 3 seconds after the switch is released.
"*4": The cleaning is conducted when the printer is idling during printing.
"*5": The Cutter Replacement Sequence can be executed in “Ready” status, and even when a warning error or Paper Out error is occurring.
"*6": During two seconds after the button is released, the printer feeds the paper at 5cps. Then the feeding speed is increased to 52 cps after a lapse of the two seconds.
The maximum back-feed amount that can be performed by pressing the button one time is less than 37 cm.
"*7": This works when REMAINING PPR SETUP in the Maintenance mode has been set to ROLL and the Roll Paper Counter setting has been made.
Enter Ejects a cut sheet when it is loaded after printing
*Does not function under conditions other than above.
When paper is loaded during printing with no error.
Roll paper: Cuts and ejects the paper
Cut sheet: Ejects the paper
During drying ink on paper
Stops drying ink and ejects the paper
*Does not function under conditions other than above.
Accepts the
change of
setting
Executes the
selected
operation
Saves the setting
---
Pause + Paper Select Enables or disables the Roll Paper Counter function when the
printer is in “Ready” mode.*
7
--- --- ---
Menu + Paper Feed +
Execution of setting
--- --- --- SERVICEMAN
MODE
Menu + Paper Select +
Paper Feed + Paper Feed
--- --- --- F/W download
Table 1-27. Button Functions (continued)
Button
Functions
Function at the
panel setting
Function
(+ Power On)
Normal One Press Hold Down for Three Seconds*
1
To Next Page
Loading...
